It’s not always very accurate but its a good indication. I have my own custom controller so Im not 100% on what the standard controller does but Im pretty sure that’s right.ĭoes your ecodan controller display the consumed and produced energy figures? That should give you the running total COP for this month, and then you can drill down to recent months and years. If the thermostats are set higher than the temperature the woodstove will heat the room too, and the control is weather comp curve on the ecodan, it should keep running. It is quite complicated, there are a lot of different factors at play.ģ7 is a good temperature if that works for you at zero or below. You can get an idea from there of the kind of temperatures folk are running at at different outside temperatures and the resulting performance. With this cold weather it’s interesting looking through the shared dashboards. New thoughts appreciated - trying to get electricity bill down to a manageable level! How do you accommodate this input into the system setup? Some days not at all depending on movements. Use it during the day and evening if we are in. The other thing I wondered is how a wood burner would influence this kind of setup. Wondering if I can go a good bit lower, set all thermostats to a high temp so they are constantly on and see what happens? Mine currently runs at 37 at zero degrees or below. I suppose my question is - how low a temperature have some of you gone on the compensation curve. If I understand correctly, they do away with the individual room thermostats and have the whole system open, trying to balance input with heat loss. I have adjusted the compensation curve over the last year or so, but I have read with interest those who manage their house temperature fully from the compensation curve (heat geeks etc). These are all fed into a heatmiser control unit and then into the Ecodan unit. I currently have 5 zones with individual thermostats and ufh and then the upstairs which has radiators on a separate circuit. However, I am wondering if I can run it more efficiently. Had a lot of issues with the original installation, but has worked ok over the years. I was directed here by someone on the green building forum.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |